Joist Hanger SPH Std Type S 47 x 200mm
0303062
£5.63 incl VAT (£4.69 excl VAT)
Each
In Stock
Product information
The BAT SPH Joist Hanger is a single piece timber to masonry hanger for building into the inner leaf of new external cavity walls and internal walls. Manufactured from 2mm thick pre-galvanised mild steel to BS EN 10327 : 2004, DX51D + Z600.
Joist Widths Available:
38mm, 44mm, 50mm, 63mm, 75mm, 89mm, 100mm, 125mm and 150mm.
Fixing Type- Built in to masonry - No mechanical fixings required to wall. 3.75x30 square twisted nails to connect joist.
- Back of hanger must be tight against wall.
- Joists are to be cut square with a gap not exceeding 6mm from the rear of the hanger.
- A minimum 675mm of set masonry must be in place over support flange before loads are applied.
- Joist to be nailled through side gusset using 3.75x30mm square twisted nails.
- The underside of joists should be notched to provide a level surface for plasterboarding.
- Single piece, non welded construction
- Non coaxial fixing holes
- 600g/m2 galvanized coating
- Manufactured 10mm less to allow for notching/joist regularisation
Video
No video available.